Hot Racing aluminum water cooled battery plate kit for the TRA DCB M41 and Spartan. This kit provides a constant heatsink to help reduce battery temperatures due to high loads. Cool water is circulated through the sealed channeled plate via a venturi pick-up at the stern of the boat. The warmed water is then discharged via the included water outlet.
FEATURES:
- Heat energy constantly sinked away from batteries via cool circulating water - Large plates to cover large batteries - CNC machined aluminum alloy for reduced weight and increased heat transfer - Factory RTV silicone permanent seal - Dual water pickup for optimal cooling - CNC machined, blue anodized, hose clamps and dual water outlet - Stainless steel hardware - Compatible with almost all batteries
YOU WILL RECEIVE:
- Two (2) cooling plates with nipples - Tubing (trim as needed) - Two (2) aluminum tubing clamps - One (1) aluminum water outlet - Two (2) stainless steel water pick-ups - Hardware
SPECIFICATIONS:
- Plate size: 147x49x6.6mm - Total kit weight: 162g
REQUIREMENTS:
- Drilling four holes in stern of boat. Two to route water inlet tubes. Two for the tubing clamp screws. - Drilling two holes in hull of boat to accommodate dual water outlet - Aluminum Hot Racing SPN28WL06 cooling hose ferrules are not included in this kit and may be purchased seperately
COMMENTS:
- Warning: the water cooler is factory sealed and should not be opened SN April 9, 2018
FEATURES:
- Heat energy constantly sinked away from batteries via cool circulating water - Large plates to cover large batteries - CNC machined aluminum alloy for reduced weight and increased heat transfer - Factory RTV silicone permanent seal - Dual water pickup for optimal cooling - CNC machined, blue anodized, hose clamps and dual water outlet - Stainless steel hardware - Compatible with almost all batteries
YOU WILL RECEIVE:
- Two (2) cooling plates with nipples - Tubing (trim as needed) - Two (2) aluminum tubing clamps - One (1) aluminum water outlet - Two (2) stainless steel water pick-ups - Hardware
SPECIFICATIONS:
- Plate size: 147x49x6.6mm - Total kit weight: 162g
REQUIREMENTS:
- Drilling four holes in stern of boat. Two to route water inlet tubes. Two for the tubing clamp screws. - Drilling two holes in hull of boat to accommodate dual water outlet - Aluminum Hot Racing SPN28WL06 cooling hose ferrules are not included in this kit and may be purchased seperately
COMMENTS:
- Warning: the water cooler is factory sealed and should not be opened SN April 9, 2018
